Governor linkage

[SpeedwayDemon]

Hi,   Does anyone know if , while attempting to put the top wire linkage from Governor to throttle plate located at top of carbuerator on a HS40,Doyou have to have carbuerator off while attempting to install and then install carbuerator to intake manifold?Iam desperate to get this on wihout it falling off at either end while I twist throttle(Which is what it's been doing!!) I would appreciat any advice on how to go about doing this.      Thanks, SpeedwayDemon

[shrike1]

I have taken carbs off HS50 and HS3.5 several times and taking off carb is the way I did it.
try and find pics of good one to compare with to make shure yours is not bent.
You will need new gasket for carb also. Hope this helps